JET-LUBE : KOPR-KOTE Industrial

ผู้ผลิต: JET-LUBE
รหัสสินค้า: KOPR-KOTE Industrial
สถานะสินค้า: Pre-Order

ราคา: 0.00บาท
ไม่รวมภาษี: 0.00บาท

จำนวน:

DESCRIPTION:

KOPR-KOTE® Industrial is a low-friction, anti-seize lubricant manufactured from a combination of micro-size copper flakes and graphite dispersed in a water-resistant grease and fortified with antioxidants, plus rust and corrosion inhibitors. KOPR-KOTE® Industrial provides protection unequaled by competitive brands.

KOPR-KOTE® Industrial provides a shield against metal-to-metal contact, preventing seizure and corrosion. It fills irregularities and imperfections and resists welding, hardening, or setting. KOPR-KOTE® Industrial provides low friction and cushions impact and shock loads. Low shear between particles reduces stick-slip, allowing quick disassembly with minimum wrench torque. It will not squeeze out of the threads, gum up, or wash off.

BENEFITS:

Retains the equipment in serviceable condition
Environmentally safe formula is free of sulfur, lead, copper, and other environmentally undesirable metals
Assures protection against rust, oxidation, and corrosion
Will not harden, evaporate, or settle out; and requires no thinning
Water resistant and excellent for rough-cut threads made of cast iron, steel, and most alloys
Has controlled frictional characteristics so that the surfaces of the nut & bolt are torque to the designed K-Factor
Assures full hydraulic efficiency by allowing the metal surfaces to slide over each other without metal-to-metal contact

DESIGNED FOR:

Specially formulated to prevent excessive over torque issues and has a very high static friction factor of 0.17, the unique blend of complex thickeners to help evenly distribute the copper flake onto the metal surfaces to eliminate metal to threaded metal contact.

RECOMMENDED APPLICATION:

Stud threads shall be thoroughly lubricated on both ends, fill the threaded area “Root-to-Crest” on the stud/bolt. The nut will push the anti-seize down the threads as it travels.
Bearing surfaces between nut and hardened waher or nut and flange should be lubricated with anti-seize in the area where the nut will rest against the flange or washer.
Anti-seize on the assembly should be easily visible.