ตะกร้าสินค้าของคุณว่างเปล่า!
JET-LUBE : SS-30
ราคา: 0.00บาท
ไม่รวมภาษี: 0.00บาท
ไม่รวมภาษี: 0.00บาท
จำนวน:
BENEFITS:
- Retains the equipment in serviceable condition.
- Environmentally preferred anti-seize thread lubricant and conductive termination compound.
- Contains high concentration of copper flakes which is required for heavy loads or compression.
- Has controlled frictional characteristics so that the surfaces of the Nut & Bolt are torque to the designed K-Factor.
- Assures full hydraulic efficiency by allowing the metal surfaces to slide over each other without metal-to-metal contact.
- Works as a similar and dissimilar metal between two metal surfaces to prevent seizing.
- This compound formula will not melt in high temperatures and improves conductivity and ground continuity.
DESIGNED FOR:
- SS-30 conductive compound for Taps, Lugs, Wiping Contacts, Drum Switches and Slip Rings
- Also used for Battery Lugs and Cables
- SS-30 Resistivity (Ohm-CM x108) 5
| Substances | Microhm-Cm | Megohm-Cm |
| COPPER FLAKE | 1.7 | |
| ZINC | 5.9 | |
| NICKEL | 10.0 | |
| GRAPHITE | 20.6 | |
| NICKEL | 21×106 |
RECOMMENDED APPLICATION:
- Stud threads shall be thoroughly lubricated on both ends, fill the threaded area “Root – to – Crest” on the stud/bolt. The nut will push the anti-seize down the threads as it travels.
- Bearing surfaces between nut and hardened washer or nut and flange should be lubricated with anti-seize in the area where the nut will rest against the flange or washer.
- Anti-seize on the assembly should be easily visible.
NOT RECOMMENDED FOR:
Not for use on oxygen lines. Not intended for use with aluminum where galvanic corrosion could be a significant issue.
เขียนข้อคิดเห็น
พิมพ์รหัสป้องกันสแปม:
