Klübersynth UH1 6-460 Synthetic gear oils for the food-processing and pharmaceutical industries based on KlüberComp Lube Technology

Product description

Klübersynth UH1 6 oils are gear oils on a polyglycol basis. They have a high scuffing load capacity and micro-pitting resistance. These oils have also proved their good wear protection in rolling bearings on the FAG FE8 test rig for gear oils.

Benefits for your application

• The oils meet the requirements according to DIN 51517-3, CLP. Corresponding gears can be switched to Klübersynth UH1 6 oils without prior consultation with the gear manufacturer provided the general application notes are observed.

• KlüberComp Lube Technology involves the selection of high-quality raw materials and individual consultation and services by Klüber Lubrication, ensuring high-performance lubrication of different gearbox components.

• Registered by NSF as H1 lubricants for use in food-processing and pharmaceutical industries, comply with FDA 21 CFR Sec. 178.3570.

• ISO 21469 certified – supports the compliance with the hygienic requirements in your production. You will find further information about ISO Standard 21469 on our website www.klueber.com.

• The oils' high micropitting resistance according to FVA 54 GFT > 10 offers sufficient protection to gears that are subject to high loads and would normally be susceptible to this type of damage.

• The good wear protection of the rolling bearings prevents premature bearing failure.

• Much longer service life than mineral oils due to the excellent ageing and oxidation resistance of the base oil; thus maintenance intervals can be extended and in certain cases even lifetime lubrication is possible.

• Owing to the wide service temperature range it is possible in many cases to use just one viscosity grade for both low and high temperatures.

• The optimum friction behaviour of the polyglycol base oil reduces power losses and improves efficiency.

• The excellent viscosity-temperature behaviour supports the formation of a sufficient lubricating film even at elevated and high temperatures.

• Seals made of 72 NBR 902, 75 FKM 585 and 75 FKM 170055 are resistant to Klübersynth UH1 6 oils.

• Approved by Siemens (Flender), Siemens Geared Motors, SEW Eurodrive, Getriebebau Nord, Stöber Antriebstechnik, Lenze, ZAE Antriebssysteme, Baldor, Boston Gear, Bonfiglioli, Watt Drive etc.

เขียนข้อคิดเห็น

พิมพ์รหัสป้องกันสแปม: